In homes built on a concrete slab, water lines often run beneath or inside the floor. When one of them leaks, the signs are indirect: a patch of floor that feels warm, the sound of running water with everything off, damp carpet or warped flooring, cracks in tile, or a water bill that jumps for no reason.
A simple test
- Turn off every faucet, the ice maker and irrigation.
- Look at the water meter and note the leak indicator or the last digits.
- Wait an hour without using water and look again. Movement means a leak somewhere on the house side of the meter.
- If the warm spot points to the hot side, close the cold inlet valve on the water heater to slow the loss.
Keep the main closed when you are not using water until the leak is found.
How plumbers find it
Leak location uses pressure tests on the hot and cold sides separately, acoustic listening equipment that picks up the hiss through concrete, and thermal imaging for hot lines. This narrows the dig to a small area instead of tearing up a room.
Three ways to fix it
- Spot repair: cut a small opening in the slab, repair the pipe, and patch the concrete. Suits a single leak in otherwise sound pipe.
- Reroute: abandon the line under the slab and run a new one through the walls or attic. Often chosen when the old pipe is thin or has leaked before.
- Repipe: replace the whole supply system, common in older Java, VA homes with aging copper or polybutylene.
Flooring repair afterward is usually a separate job, and your insurer may cover some of it.
